Wood Stairs – Read More Deeply To Help Make A Qualified Decision..

In case you are purchasing a stair with balusters in a contrasting material, like painted balusters on an oak stair, questions will more than likely arise with regards to the finishing of the stair. “Should my painter finish the balusters separately from the stair, then have the balusters set up once the stair is completed?

Here are some facts to consider with Custom Stairs: Your painter will usually choose painting the balusters before installation. This allows them to be sprayed rather than brushed and eliminates plenty of “cut-in” work.

Painting balusters separately also means the stair installers will need to return to the site, eliminate the railings and install the balusters. You will see charge with this “second trip” for the jobsite. You should make sure to schedule this “second trip” in coordination with the completing the finish.

Leaving your balusters out for painting implies that they are more inclined to be lost or stolen during this time period. You will end up in charge of balusters left on the jobsite. When the painted balusters are finally installed, you will see additional “touch-up finishing required in the rail joints. Holes will have to be filled and stain and complete re-applied for the ultimate finish.

Plan installation of your hardwood stair for after your drywall continues to be taped, sanded, and primed. The drywall process can cause damage to the stair. Drywall mud and paint overspray can make the stair finishing process very hard and may also make desired results impossible to accomplish.

Most hardwoods are an open grain wood and once dirt gets a part of open grain it is quite hard to remove, even with sanding. This can use a negative effect on the appearance and texture from the finish. Care also must be taken to safeguard the stair from dirt and mud.

Never Cover Hardwood Stairs With Plastic. Plastic will not allow airflow, trapping moisture underneath and causing the wood to grow and contract. This expansion and contraction causes the wood joints to open up up and might cause the wood to crack.

The environmental conditions inside the house are essential to the standard of the stair. Hardwood lumber has become dried by way of a very controlled process with an industry standard moisture content of 6 – 8%. This matches the moisture content vcbxbf the typical home and allows the wood to stay stable under normal conditions.

In cold climates, each time a property is heated to a high temperature during winter, the air can become very dry, causing the wood to shrink. This shrinkage will make cracks visible inside the wood and joints may start to open up. Subjecting a stair to high degrees of heat is much like putting it in an oven and can accelerate the deterioration from the stair.

All hardwoods has to be sealed on every side to retard movement and protect from exposure to elements and damage. It is recommended to seal wood immediately.

Leave a Reply

Your email address will not be published. Required fields are marked *